Create Array - TYAN TOMCAT I7221 User Manual

Tomcat i7221 S5150
Deleting Arrays
Take caution in using this option; All data on the RAID drives will be
lost! Deleted arrays cannot be restored.
1. From the Adaptec SATA HostRAID Controller#0 Array Configuration Utility menu,
select Manage Array.
2. Select the array you wish to delete and press Delete .
3. In the Array Properties dialog box, select Delete and press Enter. The following prompt
is displayed:
WARNING: Deleting the array will result in data loss!
Do you want to delete the array? (Yes/No):
4. Press Yes to delete the array or No to return to the previous menu.
5. Press Esc to return to the previous menu.

4.13.5 Create Array

Before creating arrays, make sure the disks for the array are connected and installed in your
system. Note that disks with no usable space, or disks that are uninitialized are shown in gray
and cannot be used.
===Adaptec SATA HostRAID Controller#0 Array Configuration Utility===
Main Menu
Manage Array
Create Array
Add/Delete Hotspare
Configure Drives
Create an Array
Follow the given steps to create a RAID 0 or RAID 1 Volume
1. From the Adaptec SATA HostRAID Controller#0 Array Configuration Utility menu,
select option Create Array and press the <Enter> key.
2. Select the disks for the new array and press <Ins> key. To deselect any disk, highlight
the disk and press Delete .
3. Press Enter when both disks for the new array are selected. The Array Properties menu
displays.
To assign properties to the new array:
Chapter 4: SATA/RAID Setup (for SATA RAID model)
Warning
4-31
http://www.tyan.com