Power On Setup - TYAN TOMCAT I7221 User Manual

Tomcat i7221 S5150

3.7.2 Power On Setup

Soft-Off by PWR-BTTN
This determines how long the power button needs to be pressed to switch off the PC. Options
are:
Instant-Off / Delay 4 Sec.
PWRON After PWR-Fail
This option defines the state of the system when power fails and returns again. If On is
selected, the system automatically switches on when power is resumed. If Former-Sts is
selected, the system automatically switches on and restores itself to the state it was last in
when power failed.
Former-Sts / On / Off
Wake-Up by PCI Card
If enabled, this option awakens the system from a soft off state with an input signal from PME
on the PCI card.
Enabled / Disabled
USB KB Wake-Up From S3
If you have a USB keyboard, then you must enable this function to wake-up the system with a
key press.
Enabled / Disabled
This option is enabled only if S3 or S1 & S3 is selected from the ACPI
Suspend Type option.
Resume by Alarm
This option allows your system to turn on at a pre-selected time.
Enabled / Disabled
Date <of Month> Alarm
Set the date on which the system should turn on every month. Enter 0 to disable this function.
Time <hh:mm:ss> Alarm
Set the time on which the system should turn on depending on the date setting.
Note
3-24
http://www.tyan.com
Chapter 3: BIOS Setup