TYAN TOLEDO I3010W Manual page 51

3.4.3 I/O Device Configuration
This setting allows you to configure I/O devices.
Advanced
I/O Device Configuration
Serial port A:
Base I/O address:
Interrupt:
Serial port B:
Base I/O address:
Interrupt:
Parallel port:
Mode:
Base I/O address:
Interrupt:
Floppy disk controller:
F1 Help Select Item
↑↓
Esc Exit Select Menu
Serial Port A/B:
This defines how the serial port A/B is detected and configured.
Options: Disabled / Enabled
Base I/O Address:
Set the base I/O address for serial port A/B.
Options: 3F8 / 2F8 / 3E8 / 2E8
Interrupt:
Set the interrupt for serial port A/B.
Options: IRQ3 / IRQ4
Parallel Port
This defines how the parallel port is detected and configured.
Options: Disabled / Enabled
Mode
This field allows the user to select the parallel port mode. The default value is
Standard that automatically selects the correct mode to use. The other modes are
explained as follows:
SPP works with all parallel port devices. However, it is the slowest transfer mode
and should only be used when faster transfer modes cannot be used.
PhoenixBIOS Setup Utility
[Enabled]
[3F8]
[IRQ 4]
[Enabled]
[2F8]
[IRQ 3]
[Enabled]
[Bi-directional]
[378]
[IRQ 7]
[Enabled]
-/+ Change Values
Enter Select Sub-Menu
51
http://www.tyan.com
Item Specific Help
Configure serial port A
using options:
[Disabled]
No configuration
[Enabled]
User Configuration
[Auto]
BIOS or OS chooses
configuration
(OS Controlled)
Displayed when
controlled by OS
F9 Setup Defaults
F10 Save and Exit