TYAN TOLEDO I3010W Manual page 49

3.4.2 Advanced Processor Options
This section allows you to fine-tune the processor options.
Advanced
Advanced Processor Options
Hyperthreading:
Set Max Ext CPUID = 3
Numbers of Stop Grant
C1 Enhanced Mode
Intel ® Virtualization Technology
No Execute Mode Mem Protection
Frequency Ratio
Processor Power Management:
F1 Help Select Item
↑↓
Esc Exit Select Menu
Main Advanced
Advanced Processor Options
Core Multi-Processing:
Set Max Ext CPUID = 3
Numbers of Stop Grant
C1 Enhanced Mode
Intel ® Virtualization Technology
No Execute Mode Mem Protection
Processor Power Management:
F1 Help Select Item
↑↓
Esc Exit Select Menu
Hyperthreading
Enable this only if you have an Intel Hyper Threading processor.
Hyper-Threading Technology enables multi-threaded software applications to
execute threads in parallel. Hyper-Threading Technology provides thread-level-
parallelism (TLP) on each processor resulting in increased utilization of processor
execution resources. As a result, resource utilization yields higher processing
throughput. Hyper-Threading Technology is a form of simultaneous multi-threading
technology (SMT) where multiple threads of software applications can be run
simultaneously on one processor. This is achieved by duplicating the architectural
state on each processor, while sharing one set of processor execution resources.
Hyper-Threading Technology also delivers faster response times for multi-tasking
PhoenixBIOS Setup Utility
[Enabled]
[Disabled]
[Per Core]
[Enabled]
[Disabled]
[Enabled]
[Default]
[GV1/GV3 Only]
-/+ Change Values
Enter Select Sub-Menu
PhoenixBIOS Setup Utility
Security Power
[Enabled]
[Disabled]
[Per Core]
[Enabled]
[Disabled]
[Enabled]
[GV1/GV3 Only]
-/+ Change Values
Enter Select Sub-Menu
49
http://www.tyan.com
Item Specific Help
Enabling Hyperthread-
ing activates additional
CPU threads. These
threads may appear as
additional processors
but will share some
resources with the other
threads within the
physical package.
F9 Setup Defaults
F10 Save and Exit
Boot Exit
Item Specific Help
Platform Environment
Control Interface
F9 Setup Defaults
F10 Save and Exit