Alcatel-Lucent OMNIACCESS 740 Hardware User's Manual page 55

Step 4: From SUM, you can enter the Configuration Mode (CM). The CM is used
to configure the system globally, to enter specific configuration modes or to
configure specific elements, such as interfaces or protocols.
Enter the configure terminal command to enter the Configuration mode.
Example:
ALU# configure terminal
ALU(config)#
The above steps are enough to configure the OA-740 via console.
Step 5: To configure the system remotely (Telnet, SSH, and Modem), you need to
configure basic Authentication, Authorization, and Accounting (AAA)
configuration. AAA is a system in IP-based networking to control which users
have access to the system, what resources users have access to, and to keep
track of the activity of users over a network.
To enable AAA services on your system, enter the aaa services command in the
Configuration mode.
Example:
ALU(config)# aaa services
Step 6: Set the enable password (system password). To set the system
password, enter the following command:
enable {secret|password} [5] <password>
Example:
ALU(config)# enable secret test
Secret for level 15 is set
Note: By default, only the console session is available without the enable password
configuration.
OmniAccess 740 Hardware User's Guide
Beta
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
Performing Basic Configuration Tasks
Alcatel-Lucent
47
Beta