Table of Contents
Advertisement
Installing the Driver
In this Chapter...
This chapter describes installing the driver and setting up the new
array for the drives attached to your controller. Before you get
started, you need to select from the following scenarios for
installing the controller driver on Windows, Linux, or NetWare
systems:
Installing the Driver in a New Windows System on page 2-2
Installing the Driver in an Existing Windows System on page 2-3
Installing Red Hat or SuSE Linux on page 2-3
Installing the Netware Driver in a New NetWare System on
page 2-6
Installing or updating device drivers after installing NetWare on
page 2-7
Note: You must have the most recent versions of Adaptec
Storage Manager and ARC utility installed to run the Adaptec
Embedded SATA RAID drivers.
2
2-2
2-3
2-3
2-6
2-7
2-1
Advertisement
Table of Contents
