Creating Arrays - Adaptec SATA RAID FOR Manual

4 Select the array you wish to delete then press Delete.
5 In the Array Properties dialog box, select Delete then press
Enter. The following prompt is displayed:
Warning!! Deleting the array will render array unusable. Do you want to
delete the array?(Yes/No):
6 If you press Yes, select the member when the following prompt
is displayed:
To delete the partition table, choose which member:
member #0, member #1, both, none
7 Press Esc to return to the previous menu.

Creating Arrays

Before creating arrays, make sure the disks for the array are
connected and installed in your system. Note that disks with no
usable space are shown in gray and cannot be used. See
Disk Drives on page
To create an array:
1 Turn on your computer and press Ctrl+A when prompted to
access the ARC utility.
2 From the ARC menu, select Array Configuration Utility
(ACU).
3 From the ACU menu, select Create Array.
4 Select the disks for the new array then press Insert. To deselect
any disk, highlight the disk then press Delete.
5 Press Enter when both disks for the new array are selected. The
Array Properties menu displays.
Assigning Array Properties
Note: Once the array is created and its properties are assigned,
you cannot change the array properties using the ACU.
Instead, use Adaptec Storage Manager (See
details.)
5-6.
Adaptec RAID Configuration Utility
Chapter 4
Initializing
for
5-3