TYAN NETSCALIBUR Manual page 9

4. Insert the Netscalibur CD into the CD-ROM drive. The
Netscalibur Wizard should auto-start or you can double click
on the Netscalibur CD-ROM icon to launch the
Netscalibur Wizard.
If your CD-ROM drive does not perform auto-run or
double-clicking the Netscalibur icon does not bring up
the Netscalibur Wizard, then you can run the setup
program by selecting Open from the file menu.
Afterwards, double-click sword.exe to run the setup.
5. Click on the Installation Video Clip to watch the setup
video clip first before running Setup. The video clip will
show the entire installation process and help you get a better
idea of the installation procedures. The setup process may
vary slightly between different program version.
After finishing watch the setup video clip, click on the Setup
6.
option to install the drivers and ISDN software. You must
install the following software by selecting Yes or No and
then clicking on the Continue button to go to the next step.
Please read the instructions on the monitor carefully. In
addition, please do not restart the system until you
configure the Dial-Up Networking in Part C. You can skip
Part A if you do not wish to install the modem or skip Part B
if you do not wish to install the ISDN. However, Part C is
required for internet access.
9