Table of Contents
Advertisement
Windows 95 User
Power off the system and insert the Netscalibur Card.
1
Boot to Windows 95 and select "Do not install a driver (Windows
2
will not prompt you again)."
Insert the Netcalibur CD and click on the SETUP option.
3
Install the modem drivers, ISDN acceleration pack, ISDN
4
diagnostic tool, and Internet Explorer. Add TCP/IP protocol and
Dial-Up Adapter in the Network applet. Next, restart the system.
Select "Disk provided by hardware manufacturer" and browse to
5
the Netscalibur CD's \driver\isdn directory.
6
Select Netscalibur ISDN-ISA PNP and enter the correct switch
type, ISDN phone numbers, and SPID numbers.
Windows NT 4.0 User
In the Control Panel, run the Network applet. Remove the
1
Remote Access Services (RAS) before installing the Netscalibur
drivers.
In the Adapter folder, select Add and click on the Have Disk
2
button. Enter the \driver\isdn directory of the Netscalibur CD.
Choose an IRQ, address, and switch type. Select Multi-Point and
3
enter the SPID numbers with a space between the numbers.
Next, select 64000 bps and enter the ISDN phone numbers with
a space between the numbers (do not include the area code).
Add ISDN1-Netscalibur and ISDN2-Netscalibur ISDN channels
4
and TCP/IP protocol. Finally, restart the system.
How to read the signs
Stop! Read the instructions carefully.
Caution
Please take note here.
Please follow this direction.
2
Advertisement
Table of Contents
