Table of Contents
Advertisement
Do not install Netscalibur's driver during Windows NT 3.51
installation. Please complete the Windows NT installation
first.
1
Click on the Network icon in the Control Panel.
If you already have RAS (remote access service) installed in
the system, please remove RAS before installing Netscalibur's
NT driver.
2
When Windows NT 3.51 prompts you to install a network card,
click on the NO button to skip. Then click on the Add Adapter
button to add the Netscalibur. Next, select Requires disk from
manufacturer and type in the \driver\isdn directory of the
Netscalibur CD. Select Tyan Netscalibur ISDN Modem.
3
Afterwards, you have to select an available IRQ, address, and
switch type. Since Windows NT does not support plug and play,
make sure that your selections will not cause IRQ or Address
conflicts.
4
Next, select Multi-Point and enter the SPID number of the first
and second B channels with a space between the SPIDs. Finally
select 64000 bps and type in the phone number of the first and
second B channels with a space between the two phone
numbers.
18
Advertisement
Table of Contents
