Starting A Warm Engine; Warming Up - KYMCO MXU 150 Owner's Manual

To start the engine without the electric starter
(MUX 150/50) .
1. Follow steps 1 through 6.
2. With the throttle closed, operate the kick
starter with a rapid, continuous motion.
CAUTION:
．Do not allow the kick starter to snap back
freely against the pedal stop as engine case
damage could result.
．Raise the kick starter pedal after the kick
starter lever is returned to the stop.
3. Follow steps 8 through 10.
If you cannot restart a warm engine:
1. Follow steps 1 through 4.
2. Open the throttle slightly (1/8 1/4) while
starting the engine . If the throttle limiter Is
adjusted as delivered, open the throttle fully.

STARTING A WARM ENGINE

To start a warm engine, refer to the "Starting a
cold engine" section. The choke knob should not
be used
opened slightly.

WARMING UP

To get maximum engine life, always warm up the
engine before starting off. Never accelerate
hard with a cold engine! To see whether or not
the engine is warm, check if it responds to the
throttle normally with the choke knob turned off.
－
79
CAUTION:
See the "engine break-in" section prior to
operating engine for the first time.
(MXU 250/150) . The throttle should be