Front And Rear Brakes - KYMCO MXU 150 Owner's Manual

Turn the rod (2) clockwise or
5.
counterclockwise until the drive select lever
(6) into the "N" position of the shift guide and
tighten the locknuts, then (
the standard/phillips screwdriver).
6.
After adjustment, start the engine and test
ride the ATV to be sure the drive select lever is
operating properly.
(2)
(1)
(3)
(1) Locknuts
(2) Rod
(3) Standard/phillips screwdriver
MXU 250: pull out
(See page 80~81.)
(6)
(N)
(6) Drive select lever
(N) Neutral

FRONT AND REAR BRAKES

1.
Make sure there is no brake fluid leakage.
Check operation of the levers and pedal. They
2.
should move smoothly and there should be a
firm feeling when the brake is applied. If not,
have the machine inspected by a KYMCO
dealer.
Brake operation
3.
Test the brakes at slow speed after starting
out to make sure they are working properly. If
the brakes do not provide proper braking
performance, inspect the brakes for wear.
(See page 147~149.)
63