Starting A Warm Engine - KYMCO MXU700i Manual

NOTE

If the engine fails to start, release the start switch, then
push the start switch again.

Each cranking should be as short as possible to preserve
battery energy. Do not crank the engine more than 10
seconds on each attempt.

If the battery is discharged, changing new one to start the
engine.

Spark plug inspection
To avoid damage from the vehicle's electronic fuel injection
system, do not remove or install a battery wire when the ignition
switch is at the "ON" position.
NOTE
Do not allow water enter the right case.
See the "engine break-in" section prior to operating engine for
the first time.

6.2. STARTING A WARM ENGINE

To start a warm engine, refer to the "Starting a cold engine"
section. The throttle should be opened slightly.
6.2.1. WARMING UP
To get maximum engine life, always warm up the engine before
starting off. Never accelerate hard with a cold engine! To see
whether or not the engine is warm, check if it responds to the
throttle normally.
6-3