Manual Tuning/Station Searching; Storing Stations In Preset Memories - Sangean PR-D8 Manual

Manual Tuning/Station Searching

1. Press the power button to turn the radio on.
2. Select the required waveband by pressing the band button.
Adjust the antenna as described above.
3. A single press on either the tuning up or down button will change
the frequency in the following increments:
FM: 50 or 100 kHz
AM (MW): 9 or 10 kHz
4. Press and hold either the tuning up or down button until the
frequency in the display begins to change rapidly and release
the button. Your radio will search the selected waveband and will
stop automatically when it finds a station with sufficient signal.
5. Rotate the volume control to get the required sound level.
6. To turn the radio off, press the power button. Display will
show OFF.

Storing Stations in Preset Memories

There are 5 memory presets on each waveband.
1. Press the power button to turn the radio on.
2. Tune to a required station using one of the methods
previously described.
3. Press and hold down the required station preset number until the
radio beeps. The preset number will appear in the display and
the station will be stored under chosen preset station.
4. Repeat these procedures for the remaining presets.
5. Stations stored in preset memories can be over written by the
following above procedures.
9