Setting Radio Alarm Time - Sangean PR-D8 Manual

a. Setting Radio Alarm Time
1. The radio alarm can be set in both ways (radio on or off).
2. Press and release radio alarm button
radio alarm symbol.
3. Press and hold
a beep.
4. Display hour will flash, using tuning up/down button to select hour
then press
5. Follow same procedures of setting hour to set required minute.
Press button again to complete the alarm time setting.
6. During the radio alarm time setting, the display will also flash the
last tuned radio frequency. Press tuning up/down button to
select required wake up radio station or simply press preset
station button to select wave up station.
7. Press button again to complete radio alarm setting.
8. Press and hold radio alarm button
the radio alarm. Display radio alarm symbol will disappear
followed with a beep.
Note:
If the new radio alarm station is not selected. It will select the last
programmed alarm station.
11
button for more than 2 seconds followed by
button again to confirm hour setting.
, the radio will show
for 2 seconds to cancel