VDO CONTISYS OBD Instruction Manual page 43

FastCheck
To view the next DTC (if more than 1 was found), scroll to the end of the text and press
the key.
To return to the menu, scroll to the end of the text and press the
Clear DTCs
Diagnostic trouble codes can be cleared using the 'Clear DTCs' option. When using
the option you will be prompted to turn the ignition off. Wait until prompted before
switching the ignition back on.
Start the engine to force the control module to run a system check. Verify that the
code(s) have been cleared by selecting 'Read DTCs'.
Note: Reading DTC(s) without first starting the engine will only confirm that the stored
DTC(s) have been cleared. Faults may still be present in the system causing a DTC to
be stored next time the engine is started.
BMW vehicles
Note: To switch the ignition ON for vehicles fitted with a start/stop button, insert the
remote key-fob fully into the ignition slot then press the start/stop button once (without
any foot pedals depressed).
SAS (Steering Angle Sensor) Calibration
The steering angle sensor can be calibrated using the 'SAS Calibration' option. The
on screen instructions must be performed to ensure the calibration process is
correctly completed.
Note: The steering angle sensor should be calibrated after performing the wheel
alignment or suspension adjustments.
key.
39