NorthStar EXPLORER AP380 Installation And Operation Manual page 48

3-10-3 Auto tacking or gybing in wind mode
If the set wind angle (SWA) is 90° or less, the boat tacks, if the SWA is more than 90° the boat gybes. After
the tack or gybe, the SWA is the same as the SWA before the tack or gybe, but from the
other side.
• Press , select Tack/Gybe then press
• Press , select Tack/Gybe turn then press
Example:
SWA is 40°, so the boat will tack, not gybe. If the tack angle is not set to Auto, the boat changes direction
twice:
- first by the tack angle
- second so that SWA is the same as before the tack or gybe, but on the other side:
To cancel the tack at any
time, press
Wind
Press
Tack/Gybe then press
SWA = 40°
to port.
48
The tack is finished when the boat reaches the new wind angle
After the boat has reached the tack angle, the boat turns again so
that the SWA (set wind angle) is the same as the SWA before the
tack, but from the other side
, select
to initiate a tack
Northstar Explorer AP380 System Installation and Operation Manual
to tack or gybe to port
to tack or gybe to starboard
At the end of the tack delay, the course changes by the
tack angle (in this example, the tack angle is not set to
Auto
). The boat turns.
The boat sails straight while the Explorer AP380 counts down
the tack delay.
The unit gives a long beep at 60 and 30 seconds to go, a short
beep every second from 10 seconds to 1 second to go and a
long beep that finishes when the countdown ends.
3 seconds to go until the tack starts