NorthStar EXPLORER AP380 Installation And Operation Manual page 19

Installation
1 Find a suitable location and arrangement for the unit as described above.
2 Choose, assemble and fit a suitable rudder linkage.
3 Fit the unit as shown below:
Set rudder If necessary, mount
amidships. base on block to set
height.
If necessary, cut connecting
rod at this end, then replace
coupling and lock nut.
4 Wire the cable back to the MCU600, following the wiring guide (see section 3-2-2).
Rotate base so arrow on arm
points near centre line on base.
Fit two screws provided loosely
in middle of slots.
Join coupling to
rudder linkage.
Northstar Explorer AP380 System Installation and Operation Manual
Ensure rudder is
amidships.
Snap end into
correct hole in arm.
Holes in the bulkheads must
be at least 18.5 mm (0.73")
diameter.
Plug connector into the RFU socket
Rotate base so arrow on arm
points to centre line on base.
Fit third screw provided,
tighten all screws.
MCU600
19