NorthStar EXPLORER AP380 Installation And Operation Manual page 24

Bracket mounting requires a panel for
mounting the bracket. Ensure that the panel
is not likely to deform and is not subject to
excessive vibration. The bracket can be tilted and
the dispaly can be removed after each use.
Select a position where the display unit will be:
At least 4" (100 mm) away from the compass.
•
At least 12" (300 mm) away from any
•
radio transmitter.
At least 4 ft (1.2 m) away from any antenna.
•
Easy to read and operate. If possible, mount
•
the display unit in front of the navigator or to
the right of the navigator because the LCD
display is more readable from these positions.
Not exposed to the direct sun or water.
•
Protected from physical damage during
•
rough sea passages.
Easy to access the DC power source.
•
Convenient to route the transducer cables.
•
24
PP  
Northstar Explorer AP380 System Installation and Operation Manual
Bracket mounting directions
1 Fix the mounting bracket onto the boat using
the four stainless steel screws.
2 Hold the display unit in place in the mounting
bracket. Fit the mounting bracket knobs into
the display unit and do up the knobs loosely.
3 Adjust the tilt of the display for best viewing,
then hand tighten the knobs on the
mounting bracket.
PP   PP