Configuring Pxe Server - ACRONIS SNAP DEPLOY 3 - FOR WORKSTATION Manual

You can access Acronis PXE server configuration in the following ways:
- when creating Acronis bootable media
- when creating bootable media for custom deployment mode
- using direct server configuration.
To perform the direct PXE server configuration:
1. Start Acronis Snap Deploy Management Console
2. Click Configure PXE Server
3. Connect to the server.
Configure PXE Server – click to upload Acronis Snap Deploy bootable components in the same way
as when creating Acronis bootable media. The previously uploaded components, including PE image,
will be deleted from the PXE server before uploading the newly selected ones.
Upload PE to PXE Server – click to upload the Preinstallation Environment image (.wim or .iso)
previously created with Acronis Snap Deploy PE builder. See details in
Acronis PXE Server.
Remove products from PXE Server – click to remove any component or PE from the PXE server.
Disable PXE Server – click to disable the PXE server. The service does not stop, but no longer
responds to incoming requests.
Enable PXE Server – click to enable the disabled PXE server.
42

6. Configuring PXE Server

Acronis bootable components are uploaded
15.2 Uploading PE images to
© Acronis, Inc