ACRONIS SNAP DEPLOY 3 - FOR WORKSTATION Manual page 20

Create bootable media with Acronis Snap Deploy Agent (or PE with Acronis Snap Deploy command line
utility)
or
Install Acronis PXE Server, connect the console to the PXE server and upload Acronis Snap Deploy
Agent (or PE with Acronis Snap Deploy command line utility.)
3. Do one of the following, depending on your choice in step 2:
Boot the target computer(s) into Acronis Snap Deploy Agent (or PE) from bootable media
or
Boot the target computer(s) into Acronis Snap Deploy Agent (or PE) from the PXE Server.
You must have a DHCP server or configure the target computers network settings manually to enable
the target computers to connect to Acronis OS Deploy Server.
4. Do one of the following, depending on whether the agent or the PE is running:
- Connect the console to the Acronis OS Deploy Server. Select the Deployment tab
- Make sure that the target computers IP addresses are displayed on the Deployment tab. This
means that the computers are connected and ready for deployment
- Click Manual Deployment and follow the Manual Deployment Wizard instructions to configure and
launch the deployment operation
or
- perform deployment in PE using Acronis command line utility.
20
Manual deployment
© Acronis, Inc