Dell PowerVault NX3000 Hardware Owner's Manual page 47

Table 1-2. System Messages (continued)
Message
SATA port x
device auto-
sensing error
SATA port x
device
configuration
error
SATA port x
device error
Sector not found
Seek error
Seek operation
failed
Shutdown failure General system error.
The amount of
system memory has
changed
Causes
The drive connected to the
specified SATA port is faulty.
Faulty hard drive, USB
device, or USB medium.
Memory has been added or
removed or a memory
module may be faulty.
Corrective Actions
Replace the faulty drive.
Replace the USB medium or
device. Ensure that the USB
or SAS backplane cables are
properly connected. See
"Troubleshooting a USB
Device" or "Troubleshooting
a Hard Drive" for the
appropriate drive(s) installed
in your system.
See "Getting Help."
If memory has been added or
removed, this message is
informative and can be
ignored. If memory has not
been added or removed,
check the SEL to determine
if single-bit or multi-bit
errors were detected and
replace the faulty memory
module. See
"Troubleshooting System
Memory."
About Your System
47