Dell PowerVault NX3000 Hardware Owner's Manual page 45

Table 1-2. System Messages (continued)
Message
No boot device
available
No boot sector on
hard drive
No timer tick
interrupt
PCI BIOS failed
to install
PCIe Training
Error: Expected
Link Width is x ,
Actual Link Width
is y .
Causes
Faulty or missing optical
drive subsystem, hard drive,
or hard-drive subsystem, or
no bootable USB key
installed.
Incorrect configuration
settings in System Setup
program, or no operating
system on hard drive.
Faulty system board.
PCIe device BIOS (Option
ROM) checksum failure
detected during shadowing.
Cables to expansion card(s)
loose; faulty or improperly
installed expansion card(s).
Faulty or improperly
installed PCIe card in the
specified slot.
Corrective Actions
Use a bootable USB key, CD,
or hard drive. If the problem
persists, see
"Troubleshooting an Internal
SD Card," "Troubleshooting
a USB Device,"
"Troubleshooting an Optical
Drive," and "Troubleshooting
a Hard Drive." See "Using the
System Setup Program and
UEFI Boot Manager" for
information on setting the
order of boot devices.
Check the hard-drive
configuration settings in the
System Setup program. See
"Using the System Setup
Program and UEFI Boot
Manager." If necessary, install
the operating system on your
hard drive. See your
operating system
documentation.
See "Getting Help."
Reseat the expansion card(s).
Ensure that all appropriate
cables are securely connected
to the expansion card(s). If
the problem persists, see
"Troubleshooting Expansion
Cards."
Reseat the PCIe card in the
specified slot number. See
"Troubleshooting Expansion
Cards." If the problem
persists, see "Getting Help."
About Your System
45