Installing A Raid Battery - Dell PowerVault NX3000 Hardware Owner's Manual

Installing a RAID Battery

1 Connect the battery cable to the connector on the battery.
2 Locate the battery bay on top of the hard drive bays. See Figure 3-1.
3 With the cable oriented toward the back, angle the left side of the RAID
battery into the left side of the battery bay. See Figure 3-24.
4 Rotate the right side of the battery down and press into the locked
position.
5 If not already done, route the battery cable through the right chassis wall.
See "Cable Routing."
6 Connect the battery cable to the battery connector on the storage
controller. See Figure 3-20.
Figure 3-24. Removing or Installing a RAID Battery
1 RAID battery
3 battery bay
114
Installing System Components
1
2
3
2 RAID battery cable from storage
controller