SPX OTC 5190 Operating Instructions

1
2
1. Remove all bolts from the bearing cups.
2. Slip No. 5190 U-joint puller over the driveshaft yoke as shown.
3. Use a1-1/4" wrench or socket to turn the forcing screw clockwise.
4. When the bearing cup is loose, repeat the procedure on each
bearing cup.
Important: To prevent damage to the U-joint puller, keep
forcing screw threads cleaned and lubricated.
On some older drive lines, the U-joint cross may bottom out on the
yoke before the bearing cup is completely removed. In that case,
pull back the U-joint cross far enough to allow the needle bearings
to move into the path of the trunnion. Then apply the puller again.
The U-joint cross will compress the needle bearings, and it should
be possible to remove the bearing cup.
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
U-Joint Puller
Item Part No. Qty.
1
2
3
3
Operating Instructions
Warning: To prevent personal injury when using this tool, wear
eye protection that meets ANSI Z87.1 and OSHA standards.
Tech Tip
Operating Instructions
for:
Parts List
Description
5190-3 1 Forcing Screw Kit
(forcing screw, washer, bolt)
5190-1 1 Puller Frame
5190-2 1 Puller Cup
5190-4 1 Dust Cover
Driveshaft
Yoke
Form No. 530245
(not shown)
Forcing
Screw
Bearing Cup
© 2005 SPX Corporation
Rev. A, January 10, 2005
5190