Installing The Control Panel - Dell PowerVault MD3000i Hardware Owner's Manual

Figure 3-7. Removing and Replacing the Control Panel
1
1 faceplate screws (16)
6 Using a Torx T10 driver, remove all 16 screws from the front faceplate of
the enclosure as shown in Figure 3-7.
7 Remove the front faceplate from the enclosure and place it on a flat,
secure surface.
8 Slide the control panel assembly straight out from its connector on the
backplane (see Figure 3-7).

Installing the Control Panel

1 Align the top and bottom tabs on the control panel with the insert slots on
the edge of the chassis (see Figure 3-7).
2
2 control panel
Installing Enclosure Components
3
3 thumbscrews
67