Installing Systemlock; Setting Up The First System In A User Group Or A Stand-Alone System For Use With Systemlock - Fujitsu FPCM11641 - INTEL CORE 2 DUO PROCESSOR P8600 CENTRINO Operating Manual

Security functions
In order that the users receive access to the systems within a user group, SystemLock must now be
used to create User SmartCards or Super-User SmartCards. By using a User SmartCard or Super-
User SmartCard, a user can log into any system within the user group.

Installing SystemLock

During initial installation, the first SmartCard becomes the Admin SmartCard. It has, in combination
with the PUK, all the access rights and should therefore be stored in a safe place. Only an authorised
user (Administrator) may use it, for example to initialise user cards.
If you want to set up a user group, you need an Admin SmartCard. This Admin SmartCard will be
used by you to add further systems to the user group.
Setting up the first system in a user group or a stand-alone
system for use with SystemLock
User group
► Start the device and call up BIOS Setup.
► From the Security menu, choose the option SmartCard SystemLock.
The following SmartCard SystemLock menu will be displayed:
Security
SmartCard SystemLock
SmartCard SystemLock
Install Single PC
Install Group PC
► Insert a new SmartCard in the reader and press Enter.
New SmartCards have a preset PUK (see above).
i
You will need to know the PUK assigned to the SmartCard if you want to re-initialise a
previously initialised SmartCard.
► Enter the PUK.
80
Not Installed
[Enter]
[Enter]
Enter PIN:
Item Specific Help
Installs the security
from a SystemLock Admin
SmartCard into this PC
without modifying any
data on the SmartCard.
A correct SmartCard is
[ ]
required for a
permanent installation.
A26391-K276-Z226-1-7619, edition 2