Switching On The Device With Systemlock; Start Bios Setup - F2; Change Pin - Fujitsu FPCM11641 - INTEL CORE 2 DUO PROCESSOR P8600 CENTRINO Operating Manual

The activation code can only be used once to start the device;
i
it becomes immediately invalid, once the device starts to run. If you switch off the device
and want to start it again without your SmartCard, you must first
repeat the procedure described above each time.

Switching on the device with SystemLock

If you have an internal SmartCard reader, you can switch on the device by inserting the SmartCard. If
you use the ON/OFF switch to switch on the device, the following message appears:
Insert a SmartCard.
► Insert your SmartCard.
Enter PIN:
► Enter your PIN.
The following appears: ACCESS DENIED = You have entered an incorrect PIN. After three failed
attempts, the SmartCard will be blocked and can only be enabled again by entering the PUK.
Depending on the rights assigned to your SmartCard, you can select the following functions when
this message is displayed on the screen:
F2=Setup, F3=Change PIN
If your SmartCard has the appropriate rights, you can:
F2 – Start BIOS Setup.
F3 – Change the PIN.
If you do not select a function, the system will boot up.
Start BIOS Setup – F2
A SmartCard with the appropriate rights must be inserted (SuperUser, Service or Admin).

Change PIN

Possible for every initialised SmartCard.
► Press function key F3 .
► Enter the old PIN.
► Enter the new PIN.
For the new PIN, 4 to 8-digit numbers are acceptable.
i
For security reasons, we recommend that the PIN of every SmartCard
should be changed and an eight digit number should be used.
► Confirm the new PIN.
A26391-K276-Z226-1-7619, edition 2
Security functions
87