Terminal Emulator Display Settings; Terminal Emulator Connection Settings - HP 2000i User Manual

2. Use the provided micro-DB9 serial cable to connect controller A to a serial port on a host computer.
Your package contents include a micro-DB9-to-DB9 serial cable. If necessary, use a DB9-to-DB25 adapter
(not included) for connecting the serial cable to a DB25 serial port on the host computer.
3. Start and configure a terminal emulator, such as HyperTerminal or VT- 1 00, using the display settings in
Table 4 and the connection settings in
Table 4

Terminal emulator display settings

.
Parameter
Terminal emulation mode
Font
Translations
Columns
Table 5

Terminal emulator connection settings

Parameter
Connector
Baud rate
Data bits
Parity
Stop bits
Flow control
4. In the terminal emulator, connect to controller A.
5. Press Enter to display the CLI prompt (#).
6. At the prompt, type the following command to set the values you obtained in Step 1 for each Network
port, first for controller A and then for controller B:
set network-parameters ip
where:
•
address
•
netmask
•
gateway
• a|b specifies the controller whose network parameters you are setting
For example:
# set network-parameters ip 192.168.0.10 netmask 255.255.255.0 gateway
192.168.0.10 controller a
28 Installing the enclosures
Value
VT- 1 00 or ANSI (for color support)
Terminal
None
80
Value
COM1 (typically)
1 15,200
8
None
1
None
address
is the IP address of the controller
is the subnet mask
is the IP address of the subnet router
iS C S
I 1 iS
C S I
2
C L I
C L I
Table 5.
netmask netmask
S e r v
ic e
D IR T
S A S
Y
1
C A C
H E
A C T
IV IT Y
L IN K
Connect serial cable to CLI
port on controller faceplate
gateway gateway controller a|b