HP 2000i User Manual page 29

# set network-parameters ip 192.168.0.11 netmask 255.255.255.0 gateway
193.168.0.10 controller b
7. Type the following command to verify the new IP addresses:
show network-parameters
Network parameters, including the IP address, subnet mask, and gateway address are displayed for
each controller.
8. Use the ping command to verify network connectivity.
For example:
# ping 192.168.0.10 (gateway)
Info: Pinging 192.168.0.10 with 4 packets.
Success: Command completed successfully. The remote computer responded
with 4 packets.
9. In the host computer's command window, type the following command to verify connectivity, first for
controller A and then for controller B:
ping controller-
If you cannot your access your system for at least three minutes after changing the
IP address, your network might require you to restart the Management Controller(s) using the serial
CLI. When you restart a Management Controller, communication with it is temporarily lost until it
successfully restarts.
Type the following command to restart the management controller on both controllers:
restart mc both
10. When you are done using the CLI, exit the emulator.
IP-address
HP StorageWorks 2000i G2 Modular Smart Array User Guide 29