MACROMEDIA COLDFUSION 4.5-ADMINISTRING COLDFUSION SERVER Manual page 37

Chapter 1: Installing and Configuring ColdFusion
Note
8. Enter the name of the Web server you are running and press Enter or just press
Enter if you are running the default Web server (Netscape Enterprise Server).
9. Press Enter to have the installation program automatically configure the Web
server.
The program loads the necessary plug-in for Netscape or module for Apache 1.3.x
Web servers.
10. When prompted with whether to install ClusterCATS, press Enter to do so.
11. If you want the server on which you are installing ClusterCATS to be able to
assume the IP address and HTTP traffic of a failed server in the cluster, press Enter
to configure this server with failover services. Otherwise, enter
Typically, you want all of the servers in your cluster to be configured for failover,
particularly if all of the servers have the same processing capacity. However, if you
have a mixed server environment with some high capacity servers and several
lower capacity servers, you may not want the less powerful machines to accept the
additional load of unavailable servers in the cluster.
12. Enter your Web server's document root directory and press Enter.
The default document root directory is determined by the Web server you are
using.
13. When asked if you want to install Advanced Security, enter
You can install Advanced Security at a later time by re-running the pkgadd utility.
14. Enter the password you want to use to access the ColdFusion Administrator,
which allows you to configure and modify settings for the ColdFusion Server.
You'll be asked to re-enter the password for verification purposes.
15. Enter the password you want to use to connect to ColdFusion Server when
developing applications with ColdFusion Studio.
You'll be asked to re-enter the password for verification purposes.
16. Press Enter to install the ColdFusion documentation.
The documentation is installed in the /
Web root directory.
17. Enter the user name under which ColdFusion will run or press Enter to run under
the default user name (
18. Press Enter to begin the installation.
When the installation is complete, a shell script restarts the Web server and starts
ColdFusion services. If the ColdFusion services are not started automatically, you can
start them manually using the ColdFusion start-up script, which is found in the
directory. See "Using scripts to start and stop ColdFusion manually" on
inet.d
page 22.
If you specified a directory other than the default, the installation
script will create a symbolic link from
you installed ColdFusion.
).
nobody
/opt/coldfusion
n
and press Enter.
n
directory, which resides under the
cfdocs
15
to wherever
and press Enter.
/etc/