6.
The Create New Array screen shows the disks you can add to make up
the IM volume. Use the arrow key to select a disk, then move the cursor to
the RAID Disk column. To include this disk in the array, press <+>, <->, or
<Space>.
You may also specify the Hot Spare disk here. Select the disk, then move the
cursor to the Hot Spr column, then press <+>, <->, or <Space>.
LSI Logic Config Utility
Create New Array -- SAS1068
Array Type:
Array Size(MB):
Slot
Device Identifier
Num
0
SEAGATE ST373454SS
1
SEAGATE ST373454SS
2
SEAGATE ST373454SS
3
SEAGATE ST373454SS
Esc = Exit Menu
SPACE/+/- = Select disk for array or hot spare
By default, the RAID Disk field shows No before array creation. This field is
grayed out under the following conditions:
•
The disk does not meet the minimum requirements for use in a RAID array.
•
The disk is not large enough to mirror existing data on the primary drive.
•
The disk has been selected as the Hot Spare for the RAID array.
•
The disk is already part of another array.
ASUS DSEB-D16 Series
v6.18.00.00 (2007.08.07)
IM
------
RAID
Disk
0003
[NO]
0003
[NO]
0003
[NO]
0003
[NO]
F1/Shift+1 = Help
Hot
Drive
Pred
Spr
Status
Fail
[NO]
------- ----
[NO]
------- ----
[NO]
------- ----
[NO]
------- ----
C = Create array
Size
(MB)
70007
70007
35003
35003
5-41