Appendix C Cabling Specification; Identifying A Rollover Cable; Console Port Cables And Pinouts - Cisco AS5400HPX Installation Manual

Console and Auxiliary Port Cables and Pinouts

Identifying a Rollover Cable

You can identify a rollover cable by comparing the two modular ends of the cable. Holding the cables
side by side, with the tab at the back, the wire connected to the pin on the outside of the left plug should
be the same color as the wire connected to the pin on the outside of the right plug. (See
your cable was purchased from Cisco Systems, pin 1 will be white on one connector, and pin 8 will be
white on the other connector (a rollover cable reverses pins 1 and 8, 2 and 7, 3 and 6, and 4 and 5).
Figure C-1

Console Port Cables and Pinouts

Use the RJ-45-to-RJ-45 rollover cable and RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL) to
connect the console port to a PC running terminal emulation software.
the console port to a PC.
RJ-45-to-RJ-45 rollover cable, and the RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL).
Figure C-2
Universal gateway
Cisco AS5400 Universal Gateway Chassis Installation Guide
C-2
Identifying a Rollover Cable
Pin 1 and pin 8
should be the
Pin 1
Table C-1 lists the pinouts for the asynchronous serial console port, the
Connecting the Console Port to a PC
RJ-45-to-RJ-45
rollover cable
same color
Pin 8
PC
RJ-45-to-DB-9 adapter
(labeled TERMINAL)
Appendix C Cabling Specifications
Figure C-1.) If
Figure C-2 shows how to connect
OL-2847-02 0A