Security (Cont'd)
How to Hide a Control Panel Message
When the Control Panel Message is displayed, press the HIDE
button to address the condition later.
SCREEN
How to Disarm the System
IMPORTANT: If you return and the main burglary sounder is on,
DO NOT enter the premises, but call the police from a nearby safe
location. If you return after an alarm has occurred and the main
sounder has shut itself off, the TouchCenter will beep rapidly upon
entering, indicating that an alarm has occurred during your absence.
LEAVE IMMEDIATELY and CONTACT THE POLICE from a
nearby safe location.
The system may be disarmed using either of two methods. One
method is employed when you enter the premises and the other is
when you have been in the premises with the system armed (i.e., Stay
and Night arming modes).
To disarm the system when entering the premises:
The TouchCenter will automatically display the Entry Delay Active
screen when you enter the premises:
SCREEN
22
ACTION
1. Press the HIDE button to clear the
Control Panel Message later.
ACTION
Enter your Code. The partition will be
disarmed and the "Arming" screen is
displayed showing the system as Ready
to Arm.