Touchcenter "Arming" Screen - Honeywell 6272CV User Manual

TouchCenter "Arming" Screen

From the "Home" screen, press SECURITY to access the TouchCenter
"Arming" screen. Use this picture and the table that follows to
become familiar with the TouchCenter security functions.
Note: The Voice Status Icon (
indicates the TouchCenter Voice feature. This button causes the
TouchCenter to announce system status if pressed at least 10 seconds
following its last press. Note that Voice must be enabled (by the
installer) for this button to function correctly during an alarm
condition.
ITEM
AWAY Press this button to arm when no one will be staying on the premises.
When armed in AWAY, the system will sound an alarm if a protected door
or window is opened, or if any movement is detected inside the premises.
You may leave through the entrance door during the exit delay period
without causing an alarm. You may also re-enter through the entrance door,
but must disarm the system with your User Code within the entry delay
period or an alarm will occur.
STAY Press this button to arm when you are staying home, but might expect
someone to use the entrance door later.
When armed in STAY, the system will sound an alarm if a protected door or
window is opened, but you may otherwise move freely throughout the
premises. Late arrivals can enter through the entrance door without causing
an alarm, but they must disarm the system within the entry delay period or
an alarm will occur.
NOTE: On some residential systems, if you press the Voice Status Icon
while armed in the Stay Mode, the exit delay time will restart (if the feature
was enabled by your installer).
NIGHT Press this button to arm when you are staying home and do not expect
anyone to use the entrance door. Your installer may have configured
NIGHT Mode differently; have him/her describe the actual settings of this
mode.
About the TouchCenter (Cont'd)
) shown in the above illustration
FUNCTION
9