Advertisement
Chapter 2
Installing the Cisco ONS 15530
Pull the fan assembly out of the bay and put it aside. See
Step 9
Figure 2-23
Place the new fan assembly into the front chassis cavity so it rests on the chassis. Lift the fan assembly
Step 10
up slightly and align the top and bottom guides.
Step 11
Push the fan assembly into the chassis until the captive installation screws meet the chassis.
Tighten each of the captive installation screws.
Step 12
Power up the system and verify fan assembly operation by checking the fan assembly status. The fan
Step 13
status is normal when the fan assembly LED is green.
Power Guidelines
Follow these precautions and recommendations when planning power connections to the
Cisco ONS 15530:
•
•
Caution
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations.
OL-7706-01
Fan Assembly
Check the power at your site before installation and periodically after installation to ensure that you
are receiving clean power. Install a power conditioner if necessary.
Provide proper grounding to avoid damage from lightning and power surges.
Figure
2-23.
Cisco ONS 15530 Hardware Installation Guide
Power Guidelines
2-29
Advertisement
