Advertisement
Chapter 2
Installing the Cisco ONS 15530
Attach the appropriate cables.
Step 4
Check the LEDs to ensure proper installation.
Step 5
Installing OSC Modules, WB-VOA Modules, and PB-OE Modules
Up to two OSC modules can be installed in the carrier motherboard, one module for the west direction
and one for the east direction. The WB-VOA module and PB-OE module are also installed in the carrier
motherboard.
To install the OSC module, the WB-VOA module, or the PB-OE module, follow these steps:
Disconnect all optical fiber connections from the WB-VOA and PB-OE modules.
Step 1
Remove the module or the filler module from the carrier motherboard.
Step 2
Step 3
Take a new module from the shipping container.
Step 4
Insert the module carefully into the carrier motherboard (see
and lower edges of the module in the tracks until its connectors come into contact with the backplane
connectors. Place the module locking lever in place, and then use a number 1 Philips screwdriver to
tighten the module locking lever.
OL-7706-01
Installing and Removing Modules
Figure
2-19) slot while guiding the upper
Cisco ONS 15530 Hardware Installation Guide
2-25
Advertisement
