Advertisement
Chapter 2
Installing the Cisco ONS 15530
Figure 2-14
Step 3
Twist the cable to secure it in the SFP.
Step 4
Install the SFP by inserting it in the muxponder.
Tip
In an unlikely event of the pull-tab is damaged or missing, use a screwdriver to push on the hinge pin to
unlock the SFP cage latch and pull the SFP out from SFP port
Removing SFP from Aggregation Cards and Muxponders
The SFPs used on the aggregation cards and muxponders have different types of connectors. The
different connector types on the SFP optics are:
•
•
•
•
Each connector requires a different method of removal.
Note
Use the show hardware command to see what SFP you have currently installed in your module.
Removing Pull Tab SFPs with RJ-45 Connectors
To remove an SFP with an RJ-45 connector from the muxponder, follow these steps:
Remove the cable from the desired SFP.
Step 1
Use the thumb on your left hand to push against the RJ-45 connector.
Step 2
Use your right hand to pull the pull tab on the SFP.
Step 3
Rotate the SFP while simultaneously pushing against the connector and pulling the pull tab. This
Step 4
releases the SFP from the latch lock of the cage. (See
OL-7706-01
Installing the 15500-XVRA-10E1 SFP
RJ-45 connector (for 8-port multi-service muxponders)
MT-RJ connector (for ESCON aggregation cards)
LC connector (for 8-port FC/GE aggregation cards)
Mini SMB coax connector (for 8-port multi-service muxponders)
Installing and Removing Line Cards or Motherboards
Figure
2-15.)
Cisco ONS 15530 Hardware Installation Guide
2-19
Advertisement
