or after a longer period of non-use
Place a container
blocked for 30 min
and hold (2.)
Please read this Instruction Manual and the safety instructions before operating the appliance!
Before longer period of non-use, for frost protection, repair:
before the 1st coffee
Plug mains +
Let water run through
Fill with fresh water
flashing(1 x per
Preheating, coffee, rinsing
(2 x per
Capsule container for 12 – 14 capsules **
Drip grid **
Irregular interval blinking:
Drip tray **
Send machine to repair
and press 3 x
cleaning agent mild
container + drip tray
After the last coffee:
Carefully read safety instructions on
Decalcifier is aggressive to surface of casing.
Preheat espresso cup:
1 cup of water
Fill in descaling kit
fluid and 0.5 l water
Water tank **
** Spare parts
for 3 seconds
(drops into capsule container)
Check mains: plug, voltage, fuse. In case of problems
call NESPRESSO Club
Water tank empty –> fill water tank
1. Open + 2. hold
Machine blocked –> point 6
Empty drip tray and
Rinse machine, see 1
Descale, if necessary –> point 7
Coffee not hot enough
Preheat cup, descale if necessary
Capsule area leaking
Position capsule correctly.
(water in capsule container)
If leakage: call NESPRESSO Club
Place a recipient
1. Lift lever 2. insert filter
3. close lever
Vinegar: Danger of damage
Irregular interval blinking
Send machine to repair or call NESPRESSO Club
. . . . . 220 - 240 V, 50 Hz, max. 1260 W
Refill descaling solution
Let decalcifier run through 2 times
one time back into tank
. . . . . max. 19 bar
. . . . . ~ 3 kg
. . . . . 1 l
NESPRESSO descaling kit
. . . . . 5
C ... 45
. . . . .
Empty, rinse, clean and fill tank
Rinse machine, see 1
This appliance may become a safety
hazard if these instructions and
Keep this instruction manual
safety precautions are ignored.
- Always close lever, never lift
Children may never use the appliance
Immediately remove plug from power
during operation. - Do not put fingers
without close adult supervision.
into capsule compartment and
capsule shaft, danger of injury. - Do not use
This product has been designed for
appliance without drip tray and drip grid.
Before cleaning/care, unplug the
domestic use only. Any commercial
- Keep appliance/cable out of reach of children.
appliance and let it cool down.
use, inappropriate use or failure to
- Never immerse either the whole
comply with the instructions, the manufacturer
machine, power cord or plug, in water or any
accepts no responsibility and the guarantee will
Do not place power cord on or near
not apply. Remove plug from from socket if not
hot parts or sharp edges etc.
in use for long periods - holiday etc.
- Never touch the cable with wet
hands. - If damaged, do not use the appliance.
7c) Do not lift lever during
Check that the voltage quoted on
the rating plate is the same as your
In order to avoid danger, all repairs to the power
descaling process. 7d) Rinse the
cord, must only be carried out by the Nespresso's
water tank and clean the machine to avoid any
voltage. - Connect the appliance only
authorised service agent.
residual descaling agent.
to power sockets with protective earth. The use
of incorrect connection voids warranty.
Packaging is made of recyclabe
Do not open appliance and do not
Place on a flat, stable heat-resistant
put anything into openings.
work surface away from water
splashes and any heat sources.
All operations other than normal use,
Unplug the machine and cut off the
cleaning and care must be performed by
power cord near housing. Dispose
of machine and cable at your public
Do not use machine if it is not in
disposal depot, or contact Customer
perfect working order, or if there
Services for further assistance.
is any evidence of damage. In such
cases inform Nespresso Club immediately for
FOR UK AND REPUBLIC OF IRELAND ONLY
: Always replace the fuse cover of the fitted plug, never use the plug with the fuse cover omitted.
If a replacement fuse cover is required, ensure it is the same as the one visible on the pin face of the plug
(i.e. RED or ORANGE).
Fuse covers are available from: BBS Ltd
Po Box 110
Farnham Surrey GU104XL
Phone : 01252 727755
Use a 13 A fuse approved by ASTA to BS1362, marked thus
: a plug with a bared flexible cord is hazardous if engaged in a live socket. If the fitted plug
has been cut from the power supply cord, it should be destroyed and replaced with a three pin plug in
accordance with the following code: BLUE : neutral
BROWN : live
GREEN/YELLOW : earth
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the
letter "N" or coloured BLUE or BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with
the letter "L" or coloured BROWN or RED which is connected to the fuse.
The wire which is coloured GREEN/YELLOW should be connected to the terminal marked with the letter
"E", or by the earth symbol or coloured GREEN or GREEN/YELLOW.