Magimix_D100_0605_1 14.7.2005 11:28 Uhr Seite 2
Capsule container for 12 - 14 capsules *
Drip grid *
Drip tray *
or after a longer period of non-use
Remove plastic film
before the 1st coffee
Fill water tank with
Please read this Instruction Manual and the safety instructions before operating the
Water tank *
Preheat cup: 1 cup of water
* Spare parts
Flow speed depends on coffee variety
Fill water tank
Place a container
Plug into mains +
Programming the fill up level
Rinse: let water run through 6x
Press and hold button for at least 3 seconds,
release at desired level
the programmed large and small coffee flows to factory settings
Press and hold big cup button for 3 secs.
After the last coffee
Carefully read safety instructions on decalcifier package.
Decalcifier is aggressive to surface of casing.
Rinse and empty
container + drip tray
Damped cloth, cleaning agent mild
Eject capsule (drops into
After long period of non-use, for frost protection and after repair.
Switch off and remove
Press small cup button & switch on
Buttons blink alternatively
Switch off (machine blocks for 10
2. push and hold for 3 secs.
min and is ready to be transported)
Check mains: plug, voltage, fuse. In case of problems
call Nespresso Club
Water tank empty –> fill water tank
1. Open + 2. push and hold for 3 secs
Rinse machine, see 1
container + drip tray
Descale, if necessary –> point 7
Coffee not hot enough
Fill with Nespresso
Place a recipient
1. Lift lever, 2. insert filter, 3. close lever 1.
Capsule area leaking
descaler and 0.5 l water
(water in drip tray)
Vinegar damages your machine.
Irregular interval blinking
Press both buttons
Let descaling solution
Refill water tank once more
simultaneously for 3 seconds
with descaling solution and
. . . . . 220 - 240 V, 50 Hz, max. 1260 W
Let descaling solution run through once again
. . . . . max. 19 bar
. . . . . ~ 3 kg
. . . . . 1 l
. . . . . 5
C ... 45
Empty, rinse and fill water
Exit: press both buttons
tank with fresh water
simultaneously for 3 secs
. . . . .
TSM SUCCESS MANUAL® Safe to use - easy to understand due to
TSM® - Total Security Management and ergonomic communication®
This appliance may become a safety
hazard if these instructions and
Keep this instruction manual
safety precautions are ignored.
- Always close lever, never lift
Children may never use the appliance
Immediately remove plug from power
during operation. - Do not put fingers
without close adult supervision.
into capsule compartment and
capsule shaft, danger of injury. - Do not use
This product has been designed for
appliance without drip tray and drip grid.
Before cleaning/care, unplug the
domestic use only. Any commercial
- Keep appliance/cable out of reach of children.
appliance and let it cool down.
use, inappropriate use or failure to
- Never immerse either the whole
comply with the instructions, the manufacturer
machine, power cord or plug, in water or any
accepts no responsibility and the guarantee will
Do not place power cord on or near
not apply. Remove plug from from socket if not
hot parts or sharp edges etc.
in use for long periods - holiday etc.
- Never touch the cable with wet
hands. - If damaged, do not use the appliance.
7c) Do not lift lever during
Check that the voltage quoted on
the rating plate is the same as your
In order to avoid danger, all repairs to the power
descaling process. 7d) Rinse the
cord, must only be carried out by the Nespresso's
water tank and clean the machine to avoid any
voltage. - Connect the appliance only
authorised service agent.
residual descaling agent.
to power sockets with protective earth. The use
of incorrect connection voids warranty.
Packaging is made of recyclabe
Place on a flat, stable heat-resistant
Do not open appliance and do not
put anything into openings.
work surface away from water
Preheat cup, descale if necessary
splashes and any heat sources.
All operations other than normal use,
Unplug the machine and cut off the
cleaning and care must be performed by
power cord near housing. Dispose
of machine and cable at your public
Do not use machine if it is not in
disposal depot, or contact Customer
perfect working order, or if there
Services for further assistance.
is any evidence of damage. In such
cases inform Nespresso Club immediately for
Position capsule correctly.
If leakage: call Nespresso Club
FOR UK AND REPUBLIC OF IRELAND ONLY
: Always replace the fuse cover of the fitted plug, never use the plug with the fuse cover omitted.
Send machine to repair or call Nespresso Club
If a replacement fuse cover is required, ensure it is the same as the one visible on the pin face of the plug
(i.e. RED or ORANGE).
Fuse covers are available from: BBS Ltd
Po Box 110
Farnham Surrey GU104XL
Phone : 01252 727755
Use a 13 A fuse approved by ASTA to BS1362, marked thus
: a plug with a bared flexible cord is hazardous if engaged in a live socket. If the fitted plug
has been cut from the power supply cord, it should be destroyed and replaced with a three pin plug in
accordance with the following code: BLUE : neutral
BROWN : live
GREEN/YELLOW : earth
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the
letter "N" or coloured BLUE or BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with
the letter "L" or coloured BROWN or RED which is connected to the fuse.
Nespresso descaling kit
The wire which is coloured GREEN/YELLOW should be connected to the terminal marked with the letter
"E", or by the earth symbol or coloured GREEN or GREEN/YELLOW.