Smartphones - Xerox XCARD-SCAN User Manual

Smartphones

You can connect the scanner to your Smartphone and scan directly to the phone's storage. When the phone is
connected to the scanner, the scanner detects the phone's memory card as the USB flash drive.
Note: If a memory card is in the scanner, remove it before proceeding with these instructions.
1. Connect the phone's USB cable to the phone.
2. Connect the other end of the USB cable to the USB port in the back of the scanner.
3. Turn on the scanner.
The LEDs on the scanner will flash until the phone is properly detected as a USB flash drive.
4. Your phone should now prompt you to choose the USB connection type. On your phone choose the USB
connection type to mount it as a disc drive.
This is the same prompt you would receive when you plug your phone into a computer with a USB cable. If you
do not see this prompt, refer to the troubleshooting steps below.
5. The LEDs on the scanner will stop flashing when the phone is properly set and detected as a USB storage
device. When the scanner is ready to scan, a single LED will be lit next to the currently selected scan function.
6. Tap the function button on the scanner to cycle through the scan options until the LED is lit next to the option
you want to use to scan.
Scans in color at 300dpi and creates a JPG (*.jpg) file.
Scans in black & white at 300dpi and creates an Adobe PDF (*.pdf) file.
Scans in color at 300dpi and creates an Adobe PDF (*.pdf) file.
7. Insert an item face up in the paper feed slot, aligned to the left side of the scanner.
Xerox Mobile Scanner
User's Guide
25