Direct Mode; Turn On Relayed Transfer - Xerox XCARD-SCAN User Manual

Direct Mode

When a Wi-Fi network is unavailable to transfer images, images can be transferred wirelessly from the Eye-Fi card to
a mobile device. This is referred to as Direct Mode.
Important: it is recommended that your iOS or Android mobile device be configured to use the same WAP you
configured for the Eye-Fi card as described in the previous section.
1. Click the Networks tab, then the Direct Mode tab.
2. Make sure the option to use Direct Mode when no known Wi-Fi networks are in range is selected.
3. Move the sliders left or right to change the wait times for the Eye-Fi card. When the Eye-Fi card is broadcasting
a network it is using the scanner battery to power the network. The recommended settings are:
Select 1 minute for Direct Mode to wait for a device to connect to it.
Select 30 seconds for the Direct Mode to stay on after the last item is received.
Click the Save button.
4.

Turn on Relayed Transfer

Relayed Transfer is enabled by default if you are uploading photos to an Online Sharing site. If you are only
uploading media to a computer destination, the Relayed Transfer option will give you the ability to automatically
transfer the media even when your computer is off. Your media will be automatically transferred via a configured
wireless network on the card to the Eye-Fi servers. When your computer is turned back on and the Eye-Fi Software is
running, it will contact the Eye-Fi Servers to download the staged media.
1. Click the Transfer Mode tab, then the Relayed Transfer tab.
2. Select the option to turn on relayed transfer.
3. Click the Save button.
Xerox Mobile Scanner
User's Guide
37