Configuring The One Touch Buttons And Autolaunch - Xerox XCARD-SCAN User Manual

Configuring the One Touch Buttons and AutoLaunch

When you installed the scanner, the software configured One Touch with all applications on your computer
that you can scan to. The button consists of: a Destination Application, a Scan Configuration, and a File
Format.
To open the One Touch Properties window:
There are two methods you can use to open the One Touch Properties.
• Press, hold down for at least 3 seconds, then release either of the One Touch scanner buttons.
• Left click on the One Touch icon in the lower-right corner of your screen, then right-click on one of the
destination icons.
Right click on a button, or press the button
on the scanner to open the One Touch
Properties.
NOTE: Some of the options on the One Touch Properties Window are "grayed out" and are not available,
these options are not appropriate for your scanner model.
Changing the button settings:
1. Click on an application name in the Select Destination list.
2. Select a file format in the Select Format panel.
3. Select a scanning configuration in the Select Configuration list.
4. Click on OK to save the changes.
5. Place a page in the scanner.
6. The scanner starts scanning and sends the image to the application, with the file format and scanning
configuration you specified.
NOTE: The next section contains detailed information on making changes to the One Touch Properties
window.
Xerox Card Scanner 200 User's Guide
Scanning
23