Eco Setpoint Changeover - Siemens Synco 700 RMZ788 Basic Documentation

Enabling
Configuration
Function diagram
Setting values
Siemens
Building Technologies
11.5

Eco setpoint changeover

N.X1 N.X2
This function allows for changeover to Eco setpoints.
To activate this function, configure the relevant digital input.
Eco setpoint changeover is available at controllers 1...3.
Main menu > Commissioning > Extra configuration > Controller 1...3 >
Operating line
Setpoint switch
Seq. 1
Eco Setpoint Setpoint
low low
11.5.1 Setpoints
Main menu > Commissioning > Settings > .... or
Main menu > Settings > Controller 1...3 > Setpoints >
Operating line
Eco setpoint high
Eco setpoint low
Switching and monitoring device RMS705B
Universal controller
Adjustable values / Comment
---, N.X1, N.X2, ...
(digital values only).
Seq. 4
Range Factory setting (type-dependent)
Depending on 28 °C, 28 K, 80 %, 12 g/kg, 50 kJ/kg,
selected type. 1000 W/m2, 15 m/s, 100 bar, 1000
mbar, 1000 Pa, 1500 ppm, 100, 1000
Depending on 19 °C, 19 K, 20 %, 4 g/kg, 0 kJ/kg,
selected type. 200 W/m2, 0 m/s, 0 bar, 0 mbar, 0 Pa,
0 ppm, 0
175 / 216
CE1P3124en
01.04.2010