Function Button Setting - Sony LMD1750W Operating Instructions Manual

FUNCTION BUTTON SETTING

USER CONFIG – FUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
Submenu Setting
F1 BUTTON to F4 Assigns the function to the function
BUTTON buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, EXT SYNC, BLUE
ONLY, MONO, MARKER, H/V
DELAY, MULTI DISPLAY, CLOSED
CAPTION and APA.
Factory setting
• F1 button: EXT SYNC
• F2 button: SCAN
• F3 button: ASPECT
• F4 button: H/V DELAY
About the function assigned to the
function button
SCAN
Press to change the scan size of the picture according to
the setting of "STANDARD" or "FULL+NATIVE"
selected in SCAN (page 23).
ASPECT
Press to set the aspect ratio of the picture, 4:3 or 16:9.
Note
The panel of the monitor is 15:9.
When the 16:9 signal is displayed, black bars appear in
the upper and lower positions of the display. This is not
a malfunction. (See "Scan mode image" on page 24.)
EXT SYNC (external sync)
Press to operate the unit on an external sync signal
through the EXT SYNC IN connector.
EXT SYNC works when the component/RGB signals
are input.
BLUE ONLY
Press the assigned button to eliminate the red and green
signals. Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
VCR noise.
26
Adjustment Using the Menus
xxxx
xxxx
xxxx
xxxx
MONO
Press the assigned button to display a monochrome
picture. When the buttons is pressed again, the monitor
switches automatically to color mode.
MARKER
Press to display the marker. Set the aspect marker and
safety area size in the MARKER SETTING menu (see
page 24).
H/V DELAY
Press to observe the horizontal and vertical sync signals
at the same time.
MULTI DISPLAY
Press the assigned button to display the multi display.
Set the multi display setting in the MULTI DISPLAY
SETTING menu (see page 25).
CLOSED CAPTION
Press the assigned button to display the closed caption.
Set the closed caption setting in the CLOSED
CAPTION SETTING menu (see page 26).
Not available for the signal input in BKM-227W.
APA (Auto Pixel Alignment)
Press to adjust the picture automatically to maximum
clarity for the signal input to the HD15 input connector.
For finer according to the input signal, see "DOT
PHASE" on page 22.
When the menu screen is displayed, the APA does not
function.
Note
If the APA operation does not finish correctly depending
on the input signal, adjust DOT PHASE (page 22).
CLOSED CAPTION SETTING
For the composite or Y/C input
USER CONFIG – CLOSED CAPTION SETTING
C L O S E D C A P T I O N E N A B L E :
C A P T I O N V I S I O N :
xxx
xxx