User Config Menu - Sony LMD1750W Operating Instructions Manual

USER CONFIG menu

The USER CONFIG menu is used for setting the
system, marker, multi display, function button, closed
caption and audio.
USER CONFIG
S Y S T E M S E T T I N G :
M A R K E R S E T T I N G :
M U LT I D I S P L AY S E T T I N G :
F U N C T I O N B U T T O N S E T T I N G :
C L O S E D C A P T I O N S E T T I N G :
A U D I O S E T T I N G :
SYSTEM SETTING
USER CONFIG – SYSTEM SETTING
M AT R I X :
C O M P O N E N T L E V E L :
N T S C S E T U P :
S C A N :
F O R M AT D I S P L AY:
L A N G U A G E :
P O W E R S AV I N G :
P I C T U R E D E L AY M I N :
Submenu Setting
MATRIX Applied to 480/60I or 480/60P
signal. Select 601 or 709.
COMPONENT LEVEL Selects the component level from
among three modes.
• SMPTE: for 100/0/100/0 signal
• BETA0: for 100/0/75/0 signal
• BETA7.5: for 100/7.5/75/7.5
NTSC SETUP Selects the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
SCAN Enables setting of the scan mode by
the button which the scan function
is assigned. Select either
"STANDARD" or
"FULL+NATIVE". The displayed
picture differs according to the
selected mode (see "Scan mode
image" on page 24).
When STANDARD is selected
NORMAL scan (0 % scan) and
OVER scan (5 % over scan)
When FULL+NATIVE is
selected
NORMAL scan, OVER scan,
FULL screen and NATIVE (1080i,
720P, 480i, 575i, 480P and 576P)
xxx
xxxxx
x
xxxxxx
xx
E N G L I S H
xx
x
signal
Submenu Setting
FORMAT DISPLAY Selects the display mode of the
signal format and scan mode.
• ON: The format and scan mode
• OFF: The display is hidden.
• AUTO: The format and scan
LANGUAGE Selects the menu or message
language from among seven
languages.
• ENGLISH: English
• FRANÇAIS: French
• DEUTSCH: German
• ESPAÑOL: Spanish
• ITALIANO: Italian
•
•
POWER SAVING Sets the power saving mode on or
off. When you set to ON, the
monitor goes into power saving
mode if no signal is input for about
one minute.
PICTURE DELAY MIN Selects to set the delay by the
picture processing to the minimum
level when the interlace signal is
input.
• 0: Mode for giving precedence to
• 1: The processing time is short
• 2: The processing time is shorter.
are always displayed.
mode are displayed for
about 10 seconds when the
input of the signal starts.
: Japanese
: Chinese
the picture quality. It takes
longer than "1" or "2" for
processing the picture. "0"
is the factory setting.
and this is a mode suitable
for an animation. Even
when the picture is
constructed by one field
such as the proxy picture of
XDCAM, a smooth picture
is displayed.
As the line flicker is
displayed in this mode, it is
available for checking the
line flicker of the telop work
and so on.
23
Adjustment Using the Menus