Multi Display Setting - Sony LMD1750W Operating Instructions Manual

MULTI DISPLAY SETTING

USER CONFIG – MULTI DISPLAY SETTING
M U LT I D I S P L AY E N A B L E :
M U LT I D I S P L AY:
S U B I N P U T S E L E C T :
P O S I T I O N :
F R A M E :
Submenu Setting
MULTI DISPLAY Selects ON to display the multi display
ENABLE and OFF not to display.
Notes
• When the frame frequency of the
main display is different from that of
the sub display, the picture may be
disturbed. When no signal is input to
the main display, the picture may not
be displayed correctly.
• When the multi display is enabled,
the marker display is not available.
MULTI DISPLAY • PIP/POP: The sub display is put in the
main display for the 16:9 display
and by the side of the main
display for the 4:3 display.
Display size is fixed.
• SIDE BY SIDE: The main display is
put in the left side of the display
and the sub display is put in the
right side of the display.
Notes
• When the HD15 or DVI signal is
input to the main display, SIDE BY
SIDE cannot be selected on the menu.
• When MULTI DISPLAY is set to
SIDE BY SIDE, CTI (page 21) is not
available.
xxx
xxx
xxx
x
x
Submenu Setting
SUB INPUT Sets the input signal of the sub display.
SELECT You can select from among
COMPOSITE, Y/C, RGB,
COMPONENT, OPTION A-1, OPTION
A-2, OPTION B-1, OPTION B-2,
VIDEO WAVE and OFF.
When you select VIDEO WAVE, the
waveform and audio level are displayed.
(Audio level is displayed only when you
connect the BKM-220D/243HS.)
The indications of the waveform and
audio level signify as illustrated below,
although the percentage of the
waveform, audio level L/R CH, units
and values of the scale do not appear on
the display.
Waveform
109%
100%
75%
50%
25%
0%
-4%
Notes
• The multi display with COMPOSITE
and Y/C, RGB and COMPONENT,
OPTION A-1 and OPTION A-2, and
OPTION B-1 and OPTION B-2 is not
displayed.
• When SUB INPUT SELECT is set to
OFF, the sub display is not displayed
even if you set MULTI DISPLAY
ENABLE to ON.
POSITION Sets the position of the sub display. You
can select from among 1 to 3 for the 4:3
display and 1 to 4 for the 16:9 display.
4:3 display
• 1: Top
• 2: Center
• 3: Bottom
16:9 display
• 1: Bottom left
• 2: Bottom right
• 3: Top right
• 4: Top left
FRAME Sets the position of the main display
when MULTI DISPLAY is set to POP
and the sub display is put on the 4:3
display.
• RIGHT: The main display is put by
the right side of the sub display.
• LEFT: The main display is put by the
left side of the sub display.
Audio level
(dB)
0
-10
-20
-30
-60
L CH R CH
25
Adjustment Using the Menus