Table of Contents
Advertisement
Hardware Installation
This section will assist you quickly in installing your system hardware. Wear a wrist ground strap
before handling components. Electrostatic discharge may damage your system components.
CPU Processor Installation
This mainboard supports Intel
system, we suggest you to visit the Intel website and review the processor installation procedures.
http://www.intel.com
CPU Socket 478 Configuration Steps:
Locate the CPU socket on your mainboard and nudge the lever away from the socket. Then lift
lever to a 90-degree angle.
On the socket, locate the corner that has the pin-1 receptor. This corner will be near the end of the
lever on the socket. Match the dot on the CPU with the pin-1 receptor on the socket and lower the
CPU onto the socket. The bottom of the CPU should be flush with the face of the socket.
Lower the lever
back into position. This will lock down the CPU.
Smear thermal greas
e on top of the CPU. Lower the CPU fan onto the CPU and u
fan to attach it to the socket. Finally, extend the power cable from the fan and insert it onto the
JCFAN1 header.
Attention: Before starting the system
Please check the installation completely before st
Verify that the heatsink is properly installed and make sure the CPU
fan is working. Overheating can damage the CPU and other
sensitive components.
®
®
Pentium
4 processors using a Socket 478. Before building your
Pin1 Receptor
6
the
Dot
until it snaps
se the clasps on the
arting the system.
Advertisement
Table of Contents
