Related Manuals for Sierra C100H
Summarization of Contents
Introduction to Smart-Trak 2
Safety Information
Provides crucial safety warnings and cautions for instrument operation and handling.
Definitions Used in the Manual
Defines key terms such as Setpoint, Full scale, Purge, and LFE for clarity.
Smart-Trak 2 Flow Sensing Principle
Explains the heat transfer and thermodynamic principles behind the flow measurement.
Installation Guide
Before You Begin Installation
Ensures site conditions and instrument configuration match application requirements.
Pre-Installation Checklist
Covers O-ring compatibility, filter installation, and location considerations before mounting.
Installing the Instrument—Plumbing
Details installation procedures for various plumbing connections.
Mechanical and Electrical Connections
Guides on mechanical mounting and electrical connections via the HD DB-15 connector.
Instrument Power and Grounding
Specifies power supply requirements and essential grounding procedures for reliable operation.
Analog Operation of Smart-Trak 2
Analog Operation Modes
Describes operation for Mass Flow Meters and Controllers using analog signals.
Smart-Trak 2 Features
Details Setpoint Adjustment, Output Signals, and Over-Range conditions.
Manual Valve Override Functions
Explains 'Valve Close' and 'Valve Purge' functions for manual control.
Important Safety Notes About Purging
Crucial safety warnings for purging toxic or corrosive gases.
Digital Operation with Pilot Module
Pilot Module Features and Operation
Overview of Pilot Module capabilities and operation for meters and controllers.
Pilot Module User Interface
Describes Upper Level and Lower Level screens for navigation and parameter changes.
Digital Operation with RS-232 and Software
Software Overview and Setup
Summary of software features, powering up, and software installation.
Connecting and Communicating with the Software
Guides connection via serial/USB ports and establishing software communication.
Technical Support and Service
Technical Support and Contact Information
Provides guidance for troubleshooting and contact details for support.
Returning Equipment for Factory Service
Instructions and procedures for returning instruments for calibration or service.
Appendices: Reference Information
Gas Tables and K-Factor Calculations
Lists pre-programmed gases and explains K-factor calculations for other gases.
Product Specifications
Details performance and operating specifications including accuracy and flow ranges.
PIN Configuration and Wiring
Provides detailed wiring definitions for the optional communication cable.
Micro-Trak Operation and Specifications
Covers Micro-Trak introduction, installation, operation, and specifications.
Smart-Trak Basic Commands Protocol
Explains the RS-232 communication protocol and basic command structure.
Need help?
Do you have a question about the C100H and is the answer not in the manual?
Questions and answers