3 Accessing COMMAND CENTER
Network Settings
Item
Host Name
LAN Interface
SETUP GUIDE
COMMAND CENTER refers to the internal HTML web page that is installed in the
machine from which you can verify the operating status of the machine and make
settings related to security, network printing, e-mail transmission and advanced
networking.
1
Run the web browser.
2
In Address or Location, enter the machine IP address as the URL, e.g. http://
192.168.110.171/. The web page displays basic information about the machine and
COMMAND CENTER as well as the current status of the machine.
3
Select a category from the navigation bar on the left to view and set values for that
category.
4
Setting Administrator Password restricts general users' access to pages other than
the Start page. For security purposes, setting the Administrator password is highly
recommended. The default Administrator password is factory-set as admin00.
This page allows you to make the settings that are required for network printing and
sending e-mail. You must restart this machine after you have completed these
settings in order to properly register the content of those settings in the machine.
1
Click Basic -> Network.
2
Enter the correct settings in each field. The table below provides a summary of the
items displayed on the Network page.
Description
Specifies a name for the printing system network component. This name is used as
the NetBEUI printer name and as the WSD device name.
Specifies the communication rate from Auto, 10BASE-T-Half, 10BASE-T-Full,
100BASE-TX-Half, and 100BASE-TX-Full.
Accessing COMMAND CENTER
17
Need help?
Do you have a question about the FS-1028MFP and is the answer not in the manual?